Table of Contents
Advertisement
28
en | Transportation dollies
Caution!
Install with non-powered tools only. Do not use an impact driver. Do not over tighten the
!
bolts and nuts. Bolts and nuts are properly tightened when the washers under the nuts are
just beginning to sink into the wood.
Further tightening the bolts and nuts will only crush the wood.
To install the X12-125F-DAK dolly adapter kit, do the following:
1.
2.
3.
4.
5.
6.
7.
2019-07 | 04 | F.01U.310.953
Insert one X12-125F-DAK ground stack block assembly into one of the cut-outs in the
dolly top cover from the underside of the cover.
See the illustration for proper orientation.
Thread four 3/8-16 hex head bolts up through the holes in the base of the block until the
bolts are fully seated in the base of the block and the threads are protruding up through
the top surface of the dolly.
Place a washer over each protruding bolt thread and start a nylon locking nut.
Finger tighten the four nylon locking nuts.
Using a 9/16" wrench to hold the bolt heads and a 9/16" deep well socket to turn the
nuts, gradually tighten the four nuts and bolts in a crisscross pattern until the washers
under the nuts just begin into sink into the wood.
This is sufficient for maximum strength. Do not over tighten.
Using one #10-24 hex socket head cap screw, secure one pin and lanyard assembly to one
of the tapped holes in the ground stack block.
A dab of thread locker may be used, if desired, to prevent this screw from loosening.
Tighten until snug with a 5/32" hex (Allen) key. Do not over tighten.
Repeat steps 1-6 for the three remaining X12-125F-DAK ground stack block locations.
The X12-125F-DAK ground stack kit does not interfere with normal operation of the dolly
and may be left installed permanently.
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice
Advertisement
Table of Contents
