Electro-Voice X-LINE ADVANCE Series Installation Manual page 24

24 en | Transportation dollies
5.
6.
7.
8.
9.
10. Insert the front dolly ball-detent pin on the other side of the element.
11. Verify both ball-detent pins are thoroughly pushed into the dolly rail.
12. Lift the rear of the element to take the weight off the rear link bars.
13. Pull the angle lock pins.
14. Insert a quick-release pin into the ANGLE SELECT 4° hole ( ) on one side of the element.
15. Insert a quick-release pin into the ANGLE SELECT 4° hole ( ) on the other side of the
16. Verify both pins are pushed in all the way and the blue buttons are not depressed.
17. Lower the element until its weight is resting on the angle select pins.
18. Insert the second quick-release pin into the ANGLE LOCK hole 0° EVEN on one side of the
19. Insert the second quick-release pin into the ANGLE LOCK hole 0° EVEN on the other side
20. Verify both pins are pushed in all the way and the blue buttons are not depressed.
21. Insert the rear dolly ball-detent pin on one side of the element.
22. Insert the rear dolly ball-detent pin on the other side of the element.
23. Verify both ball-detent pins are pushed all the way through both dolly rails.
Adding elements 2 & 3
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Lower the element until its weight is resting on the angle select pins.
11. Insert the second quick-release pin into the ANGLE LOCK ODD/CARDIOID hole on one
12. Insert the second quick-release pin into the ANGLE LOCK ODD/CARDIOID hole on the
13. Verify both pins are pushed in all the way and the blue buttons are not depressed.
14. Orient the next element to align the front with the rear of the previously installed
2019-07 | 04 | F.01U.310.953
Repeat steps 2-4, on the other side of the element.
Identify the rear side of the dolly with the raised stop for the bottom element.
Orient the front side of the element with the front side of the dolly.
Guide the two front link bars into the V-blocks at the front of the dolly.
Insert the front dolly ball-detent pin on one side of the element.
The rear link bars will then drop if they are not already fully extended.
element.
element.
of the element.
Pull and twist the four upper captive twist lock pins on the previously stacked element.
Make sure all four captive twist lock pins are in the open position.
On the next element, lift the front of the element.
Pull and twist one of the front captive twist lock pins on the element.
The front link bar will extend.
Twist and lock the captive twist lock pin at the front of the element.
The captive twist lock pin at the front of the element should now be in the closed
position with the front link bar extended.
Repeat steps 2-4, on the other side of the element.
Pull the angle lock pins.
The rear link bars will then drop if they are not already fully extended.
Insert a quick-release pin into the ANGLE SELECT CARDIOID hole on one side of the
element.
Insert a quick-release pin into the ANGLE SELECT CARDIOID on the other side of the
element.
Verify both pins are pushed in all the way and the blue buttons are not depressed.
side of the element.
other side of the element.
element.
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice