Table of Contents
Advertisement
30
en | Transportation dollies
2.
3.
4.
5.
6.
7.
8.
9.
10. Insert one of the long ball-detent pins attached to the outrigger through the front pin hole
11. Make sure the ball-detent pin is inserted all the way through the dolly rails, subwoofer
12. Pivot the outrigger assembly on the newly installed front ball-detent pin until it is parallel
13. Insert the remaining attached long ball-detent pin into the remaining pin hole of the outer
14. Push it all the way through the corresponding pin holes in the dolly rails and out the back
15. Make sure both long pins are fully inserted through both outrigger bars and dolly rails.
16. Repeat steps 2 thru 14 for the remaining outrigger assembly.
17. Verify the short ball-detent pins securing the subwoofer link bars to the dolly rails on the
7.3
Stacking X12-128 subwoofers onto a X12-128-DOLLY
Warning!
During transportation of X12-128 subwoofers, you must secure the loudspeakers to the dolly
with the provided ratchet strap. We recommend that two people maneuver the loaded
!
subwoofer dolly. Two X12-128 subwoofers with the dolly will exceed 450 lb (204 kg). It is
possible for the subwoofers to tip over if the dolly is not handled properly.
Disregarding this warning could result in major injury or possibly death.
2019-07 | 04 | F.01U.310.953
Pull one ball-detent pin from the dolly rails of the X12-125F-DOLLY where the first
outrigger of the X12-125F-DOK outrigger kit is to be attached.
Pull the ball-detent pin from the dolly rails where the second outrigger of the X12-125F-
DOK outrigger kit is to be attached.
Pull the first long ball-detent pin from the X12-125F-DOK outrigger assembly.
Pull the second ball-detent pin from the X12-125F-DOK outrigger assembly.
Fully retract the jack screw floor pad of the outrigger.
Slide one of the outrigger assemblies onto the dolly so that it straddles the rails at one
end of the dolly.
Slide the outrigger in until the spacer block on the outrigger touches the end of the dolly
rails.
Back the outrigger assembly slightly away from the end of the dolly rails.
on the outer outrigger bar.
rigging link bar and out the back side of the opposite outrigger bar.
The short ball-detent pin attached to the dolly in this location is not used while the
outrigger assembly is in place.
with the dolly rails.
outrigger bar.
side of the opposite outrigger bar.
side of the dolly opposite the outriggers are fully inserted.
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice
Advertisement
Table of Contents
