Electro-Voice X-LINE ADVANCE Series Installation Manual page 18

18 en | Rigging system
2.
3.
4.
5.
6.
7.
8.
9.
10. Insert the second quick-release pin into desired ANGLE LOCK hole.
2019-07 | 04 | F.01U.310.953
Lift the element to take the weight off the rear link bars.
Pull the angle lock pins.
The rear link bars will then drop if they are not already fully extended.
Insert a quick-release pin into the desired ANGLE SELECT degree hole on one side of the
element.
Insert a quick-release pin into the desired ANGLE SELECT degree hole on the other side
of the element.
Verify both pins are thoroughly pushed in and the blue button is not depressed.
Make sure the same degree hole is selected on both sides.
If using double pin continue to the next step.
Lower the element until its weight is resting on the angle select pins.
Installation manual
X-LINE ADVANCE System Rigging & Transport
Electro-Voice