Table of Contents
Advertisement
Pitch
Set the print position in the vertical direction.
The setting range is from -30 to +30 dots.
When you decrease the setting value, the print position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print position moves opposite the feed direction (toward
the end part of the media).
Offset
Set the stop position of the media.
The setting range is from -30 to +30 dots.
When you decrease the setting value, the stop position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop position moves opposite the feed direction (toward
the end part of the media).
Darkness Adjust
Fine tune the print darkness of the test print.
The setting range is from 0 to 99.
0 is the lightest and 99 is the darkest.
•
You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
•
The changes to the settings in this menu are linked and are changed with each of the
test print settings under the [Test Print] menu.
•
The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[BD Address]
Perform the factory test print.
1. Check and set the items as listed on the [BD Address] menu.
2. Press the
printing.
To stop the test print, first pause printing, and then press the
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 101.6 mm (4") for [Large].
button (
) to start a test print. Press the
button (
button (
223
) again to pause
).
Advertisement
Table of Contents
