Safety Instructions - Danfoss FT1390 Operator's Manual

WARNING
Failure to follow Danfoss process and product instructions
and limitations could lead to premature hose assembly
failures, resulting in property damage, serious injury or
death. Danfoss fitting tolerances are engineered to match
Danfoss hose tolerances. The use of Danfoss fittings on
hose supplied by other manufacturers and/or the use of
Danfoss hose fittings supplied by other manufacturers,
may result in the production of unreliable and unsafe hose
assemblies and is neither recommended nor authorized by
Danfoss.

Safety Instructions

1. Prevent unauthorized
operation. Do not permit
anyone to operate this
equipment unless they
have read and thoroughly
understand this manual.
2. Wear safety glasses.
3. Avoid pinch points. Do
not rest your hand on
the crimp ring. Keep
your hands clear of all
moving parts. Do not
allow anyone, other than
the operator, close to the
equipment while it is in
operation.
4. Maintain dies with
care. Dies used in the
ET4040/FT1390 crimp
machine are hardened
steel, offering the best
combination of strength
and wear resistance for
long life. Hardened dies
are generally brittle and
care should be taken to
avoid any sharp impact.
Never strike a die with a
hardened instrument.
5. Use only specified
Danfoss products. Make
hose assemblies using
only Danfoss hose and
fittings specified for this
assembly equipment.
6. Verify correct crimp
diameters. Check and
verify correct crimp
diameters of all fittings
after crimping. Do not
put any hose assemblies
Read and understand the operator's manual before
attempting to operate any equipment.
Danfoss hereby disclaims any obligation or liability (including incidental
and consequential damages) arising from breach of contract, warranty,
or tort (under negligence or strict liability theories) should Danfoss
hose, fittings or assembly equipment be used with the hose, fittings or
assembly equipment supplied by another manufacturer, or in the event
that product instructions for each specified hose assembly are not
followed.
into service if the
crimp diameters do not
meet Danfoss crimp
specifications.
7 . Make sure all dies are
completely in place, and
the cage is positioned
properly on the pressure
plate
8. Do not over pressurize.
Do not exceed the 10,000
psi hydraulic pressure
supplied to the machine.
9. Die change. Do not insert/
remove dies while the
power is on or machine is
in operation.
Danfoss FT1390 Crimp Machine Operator´s Manual October 2022
Safety instructions
10. Secure the equipment to
a stable work surface.
Prior to operation,
secure the crimp
machine to a stable
work surface to prevent
the equipment from
tipping. See pages
4-5 for mounting
instructions.
11. Unplug the power supply
when not in use.
12. Keep work area
clean. Cluttered areas
and benches invite
accidents.
3