Module Specific Channel Configuration Errors - Spectrum Controls Micro850 User Manual

3-22 Chapter 3: Configuring the 2085sc-IF16 Using CCW
Mod_Error Extended_Error_Info
[11:9] [8:0] (hex)
(binary)
001 104
001 105
001 106
001 107

3.3.15 Module Specific Channel Configuration Errors

Mod_Err Extended_Error_Info [8:0]
or [11:9]
Reserve
(binary)
d [8]
(binary)
010 0
010 0
010 0
010 0
User's Manual Pub. 0300306-01 Rev. A
Combined
[11:0]
(hex)
304
305
306
307
The following table lists module specific channel configuration errors for the
2085sc-IF16.
For the module specific configuration errors, the Extended_Errror_Info (bits 0 –
8) field is further divided as follows:
Bits 0–3 indicate the channel (0–15) that has the configuration error. If

multiple channels have an error, only the first channel that has the error
is reported.
 Bits 4–7 indicate the specific channel configuration error.
 Bit 8 is 0 to indicate a channel configuration error.
Error Channel
[7:4] [3:0] (binary)
(binary)
0000 0000
0001 0000–1111
0010 0000–1111
0011 0000–1111
Description
ADC communication error
This hardware error is set if the module detects the
analog-to-digital converter is not functioning
properly.
(Unused by the 2085sc-IF16)
ASIC communication error
This hardware error is set if a communications
error to the ASIC from the microcontroller has
been detected.
Checksum error
This hardware error is set if the calibration data
stored in the module is missing or corrupted.
Combined Description
[11:0]
(hex)
400 General channel configuration
error, no additional information
410–41f Invalid Input Range selection
Check the Range Type setting in the
Channel Configuration data.
420–42f Invalid Input ADC Filter
selection
Check the ADC Filter setting in the
Channel Configuration data.
430–43f Invalid Input Data Format
selection
Check the Data Format setting in
the Channel Configuration data.