Canton Smart Amp 5.1 Manual page 61

English
Problem
An input cannot be
selected via the input
buttons.
A (slave)speaker
shows [WLS] in the
display.
The subwoofer does
not reproduce sound.
No connection can be
established between
the network router
and the Amp 5.1.
Your WiFi network is
not displayed during
setup.
The Smart Amp 5.1 is
not indicated in the app
on your (mobile) device.
130
Possible cause
The input has been deactivated in the Input
Config [INP] menu (---).
1. The slave speaker is operated without the
Amp 5.1.
2. The (slave-) speaker is not paired anymore.
1. The Smart subwoofer is not paired, till now.
2 The subwoofer is connected to the Amp 5.1
using a RCA cable, but Sub Out is set to Off (not
activated).
1. The DHCP server is deactivated in the router.
2. A filter for MAC addresses was created in the
network router.
3. Your router is not compatible with Chromecast
built-in.
1. The network connection for the Amp 5.1 is
set to Ethernet [ETH].
1. Your (mobile) device and the Amp 5.1 must
be conncted to the same network.
Solution
Activate the relating input according to chapter Input Config
[INP].
1. Turn on the Amp 5.1.
2. Pair the (slave-) speaker with the Amp 5.1 according
to chapter Speaker Config [SPC] / Speaker Mapping [SPM].
1. Pair the Smart subwoofer with the Amp 5.1 according
to chapter Speaker Config [SPC] / Speaker Mapping [SPM]
2. Activate the output Sub Out at the Output Config [OPC].
1. Activate the DHCP server of the network router according
to the router's instructions.
2. Deactivate the MAC Address Filter resp. add the adress of
the Amp 5.1.
3. Routers that are demonstrably compatible can be found
in the web link in the chapter "Using Chromecast built-in".
However, there are more compatible routers.
1. Change the setting to WiFi [WIF] in the menu Network
Select [NWC].
1. Connect your (mobile) device resp. the Amp 5.1 to the
corresponding network (e.g. when using a guest network).