Canton Smart Amp 5.1 Manual page 44

Please do the following to activate resp. deactivate this function:
To enter the menu, press the "M" button.
1
Use the " " or " " button to select the menu item Wireless Setup [WIS] and confirm with the "OK" button.
2
Select the first menu item Bluetooth [BT] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Autoplay [APL] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to select the desired item On [ON] or Off [OFF].
5
Confirm and exit the menu item by pressing the "M" button.
6
Note: Depending on the operating system of the (mobile) device and the app, the app must run in the foreground or at least in the
background. If there is no app or one that does not support background operation, playback will not start.
BT Reset [BRE]
This function is to reset all Bluetooth
Caution: ALL settings related to the Bluetooth
To perform the reset please proceed as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to select the menu item Wireless Setup [WIS] and confirm with the "OK" button.
2
Select the first menu item Bluetooth [BT] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item BT Reset [BRE] and confirm with the "OK" button. The menu shows "Reset", the
4
display shows [YES].
To cancel the reset procedure, press the "M" button. The display shows [BRE] again. Press this key additional three times to exit the
5
menu.
To execute the reset press the "OK" button. The display then shows [YES] to confirm the reset procedure, the OSD shows "Please
6
Wait".
After the reset procedure, the Amp 5.1exits the menu and goes into normal mode.
7
Transmission Power [TXP]
The wireless audio module of the Amp 5.1 is by default set to 25% of the maximum transmission power [ECO], according to -6dB. In most
cases this is completely adequate for a stable and non-interrupted wireless connection with Smart speakers and/or a Smart subwoofer in the
same room. In case of connection problems and/or audio dropouts you can increase the transmission power. At Medium setting [MED] the
wireless technology related settings and paired devices stored on the Smart Amp 5.1.
®
wireless module you have made and stored on the Amp 5.1 will be deleted.
®
English
3 1 13