Canton Smart Amp 5.1 Manual page 56

Problem Possible cause
The Amp 5.1 does not 1. The standby function is factory set to Network
turn on automatically. [NSB]. The system must be turned on manually.
2. The device has been switched off via the
"ON / Standby" button of the remote control
or the "Power" button of the TV remote
control (when using the IR learning function).
3. The signal from the source at the analogue
input [AUX] is too low.
The Amp 5.1 1. The standby function was set to ECO, AUT or
switches off NSB.
unintentionally.
2. The infrared command for Standby has been
learned incorrectly.
The Amp 5.1 1. The standby function is set to Manual [MAN].
does not turn off
2. The standby function Auto [AUT] is activated
automatically..
and the source device also transmits a carrier
signal in standby mode (optical or coaxial digital
input, only).
Solution
1. In order to automacially turn on, the standby function
must be switched to Auto [AUT].
2.1 Switch on the Amp 5.1 via the "ON / Standby" button
of the remote control and wait until it automatically switches
to the standby mode, next time.
2.2 Delete the "Power" button of your TV remote from the
Amp 5.1 to prevent it from switching off together with your
TV.
3. Increase the output level (volume) on your analogue
source device.
1. Select the standby function Manual [MAN] if the Amp 5.1
is meant to stay on, even without an input signal.
2. Learn the infrared command for On (turn on) resp. Standby
(turn off) again.
1. Activate the standby function ECO, AUT, or NSB.
2. Switch off the source device at its mains switch or dis-
connect it from the mains in any other way.
English
3 1 25