Canton Smart Amp 5.1 Manual page 39

English
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu Display Setup [UI] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item LED Flashing [LED] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to select the desired LED indication and confirm with the "OK" button.
5
Confirm and exit the menu item by pressing the "M" button.
6
Factory Reset [RES]
With this function you can reset the Smart Amp 5.1 to its factory settings. In case the Amp 5.1 has a mailfunction or does not connect to a
network anymore, please perform such a reset and repeat the installation process before you contact the customer support.
Caution: ALL settings you have made including IR codes, the WiFi connection and paired mobile devices and speakers will be deleted.
To perform the reset using the remote control of the Amp 5.1 please proceed as follows:
Power up your Amp 5.1 using the Power" " " key on the remote.
1
To enter the menu, press the "M" button until the display shows [SPS] and the Main Menu is entered.
2
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Select the function Factory Reset [RES] and confirm with the "OK" button. The display shows [YES], the OSD indicates "Reset All".
4
To cancel the reset procedure, press the "M" button. The display shows [RES] again. Press this key additional two times to exit the menu.
5
To execute the reset, keep "Reset All" [YES] and confirm with the "OK" button. The display then shows [YES] to confirm the reset proce-
6
dure, the OSD shows "Please Wait".
After some seconds the Amp 5.1 reboots. During this procedure the display flashes [ON] and the LED flashes green fastly.
7
To perform the reset using the touch keys on the top of the Amp 5.1 please proceed as follows:
Power up your Amp 5.1 using the Power" " " key.
1
To enter the menu, press the input select key "
2
Use the "+" or "-" key to navigate to the menu System Setup [SYS] and confirm with the Play/Pause button " ".
3
Select the function Factory Reset [RES] and confirm with the Play/Pause button " ". The display shows [YES], the OSD indicates "Reset
4
All".
To cancel the reset procedure, press the input select key "
5
the menu.
To execute the reset, keep "Reset All" [YES] and confirm with the Play/Pause button " ". The display then shows [YES] to confirm the
6
108
reset procedure, the OSD shows "Please Wait".
" until the display shows [SPS] and the Main Menu is entered.
". The display shows [RES] again. Press this key additional two times to exit