Canton Smart Amp 5.1 Manual page 60

Problem Possible cause
The Amp 5.1 1. This can happen if the function Input Select
unintentionally [SEL] is set to [AUT] and the currently selected
changes the input. analoque input [AUX] has a long break in the
playback (>10 seconds) and a signal is present at
another input or the source device is turned on
at the optical and coaxial input.
2. This can happen when your (mobile) device
plays system sounds, such as typing on the
keyboard.
Paired wireless 1 The (slave) speakers are not paired to the Amp
speakers do not turn 5.1, till now.
on together with the
2. The parameter Standby [STB] is set to ECO
Amp 5.1.
[ECO].
An input cannot be 1. The input was deactivated in the Input Config
selected via the Input [INP] menu (---).
buttons " " or " ".
The volume is 1. In the Max Volume [VOL] menu, a maximum
limited to a value volume less than 70 was selected.
less than 70.
Solution
1.1 Make sure that no signal is present at any other input
during playback at the analoque input [AUX] or
that a device is switched on at the optical and coaxial
digital input.
1.2 Deactivate the function Input Select [SEL].
2.1 Disable these system sounds on your (mobile) device.
2.2 Deactivate the function Input Select [SEL] resp. BT Select
[BTS].
1. Pair all slave speakers according to chapter Speaker Config
[SPC] / Speaker Mapping [SPM].
2. If the parameter STB is set to [ECO], each speaker must be
switched on separately with the remote control. If you want
to switch all speakers on together, set the parameter to NSB,
MAN or AUT.
1. Activate the input according to chapter Input Config [INP].
1. Increase the value according to chapter Max. Volume
[VOL].
English
3 1 29