Canton Smart Amp 5.1 Manual page 54

Network Info [NWI]
This menu item is used to view all information about the network and related settings of the Smart Amp 5.1.
The listed items have the following meanings:
• IP Adress [IP]: The IP (internet protocol) adress of the WiFi module assigned by the network-router.
• MAC Adress [MAC]:The Media Access Control adress is a unique, unchangeable identification number of the WiFi module.
• Name [NAM]: The (network)name of the Amp 5.1 that has been set during the installation process. The default name is set as
Smart Amp 5.1.
• SSID [SSI]: The name of the connected WiFi network.
• WiFi Band [BAN]: The current frequency band of the WiFi module.
• STS Wireless [WCH]: The current frequency band of the wireless audio module.
To view the network information, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu System Info [INF] and confirm with the "OK" button.
2
Select the menu item Firmware Info [FWI] and confirm with the "OK" button. All firmware versions will the be displayed as a list in case
3
you have have TV connected.
In case you do not have a TV connected to the Amp 5.1 you can select the specific firmware version by using the
4
press the "OK" button
to confirm. The information about the firmware version will then be shown as scroll text in the display.
To exit the selected info press the "M" button.
Repeat step 4 until you have all needed informations.
5
Exit the menu item by pressing the "M" button.
6
Note: • The IP address and frequency band of the WiFi module (WiFi band) can only be displayed after the Smart Amp 5.1 is connected
to your network via WiFi or network cable. If the Amp 5.1 is connected via network cable, it is not possible to display the SSID.
English
" " or " " button and
3 1 23