Canton Smart Amp 5.1 Manual page 24

If activated, the front left speaker [FL] generates a pink noise signal. Press "M" and then the Down key " ", or directly the Down key "
6
to select this left front speaker [FL] from the speaker list.
Use the "+" resp. the "-" button to change the volume level. Go back to the speaker selection list by pressing"OK".
7
To select a different speaker, use the "+" resp. the "–" key.
8
The speaker selected in the list of speakers plays back the test tone. At your listening position, all speakers should have approximately the
9
same volume level.
Only speakers that have been activated in the Output Setting [OPS] / Speaker Config [SPC] menu are selectable. Speakers that have been
10
deactivated (displayindication [NO]) can not be selected and are grayed out.
It is difficult to find the correct volume level for a subwoofer, because of the different frequency band. Therefore, adjust the Subwoofer
11
value to your preferred level.
To exit the menu item, press the "M" button. The test tone generator will be deactivated automatically.
12
Speaker Distance [DST]
An adjustment of the distance between the speakers and listening position is needed for a perfect spatial effect, especially in case of mul-
tichannel input signals. Measure and enter the distance between the speakers and your listening position. The distance is adjustable between
0.0m and 9.9m, in steps of 0.1m, where 3.0m is the factory setting.
To adjust the distance please do as follows:
To enter the menu, press the "M" button.
1
Enter the first menu item Speaker Setup [SPS] by pressing "OK".
2
Select the menu item Distance [DST] using the
3
Select the speaker that you want to adjust the distance of by using the " " or " " button and press "OK".
4
Only speakers that have been activated in the Output Setting [OPS] / Speaker Config [SPC] menu are selectable. Speakers that have been
deactivated (displayindication [NO]) can not be selected and are grayed out.
You can adjust the distance by using the "+" and "–" buttons. To go back to the speaker list press the "OK" button.
5
Press the "M" button to exit this menu item.
6
" " or " " button and confirm with the "OK" button.
English
"
3 9 3