Canton Smart Amp 5.1 Manual page 37

English
Max Volume [VOL]
You can limit the maximum settable volume with this (protective) function Max Volume in such a way that the sound level (indicated in the
On-screen or LED display of the Amp 5.1) cannot be turned up above the set value. You can set the desired volume level from 1 to 70, where
70 represented the maximum.
To change the maximum volume please do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to navigate to the menu item Max Volume [VOL] and confirm with the "OK" button.
3
Use the "+" resp. the "–" key to select the desired volume.
4
Confirm and exit the menu item by pressing the "M" button.
5
Note: This function does not limit the output volume level of the Amp 5.1 to a certain level but only the selectable volume. Based on the
incoming signal (level) the output volume can be higher or lower.
Playmode [PLM]
In this menu you can activate additional playmodes that can then be used and selected in addition to the 3 standard playmodes Stereo, Movie
and Music with the PM button on the optionally available Smart remote. These playmodes are:
• Discrete: Surround sound for movies, music, etc. without a virtualizer.
• Night: (Virtual) surround sound with reduced dynamic and higher voice clearity at low volume levels for "night usage".
• Party: Plays the front channels (L+R) additionally on the surround speakers.
• Pure Direct: Surround sound for movies, music, etc. without a virtualizer or upmixer.
To activate or deactivate an additional playmode please do as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " buttonto select the menu item Playmode [PLM] and confirm with the "OK" button.
3
Use the " " or " " button to select the desired playmode and press the "OK" button.
4
Use the "+" key to activate resp. the "–" key to deactivate the desired playmode and confirm by pressing the "OK" button.
5
To activate or deactivate a different playmode please repeat the steps 4 and 5.
6
Exit the menu item by pressing the "M" button.
7
106