Canton Smart Amp 5.1 Manual page 40

After some seconds the Amp 5.1 reboots. During this procedure the display flashes [ON] and the LED flashes green fastly.
7
3. Network Setup [NWS]
The third menu item of the Main menu includes the setup of the network connection. It contains the two items:
• Network Connection
• Network Reset [NWR]
Network Connection [NWC]
At this menu the connection way of the WiFi module is set. The module can be connected Wireless [WLA] (default) or Wired [ETH] using the
Ethernet port of the Smart Amp 5.1.
To change the connection way from wireless to wired or contrary, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu Network Setup [NWS] and confirm with the "OK" button.
2
Confirm the first item Network Select [NWC] with the "OK" button.
3
Select the desired connection way using the "+" or "-" key, [WIF] for a wireless resp. [ETH] for a wired network connection and confirm
4
with the "OK" button.
Press the "M" button to exit this menu item.
5
Network Reset [NWR]
This function is to reset all network settings stored on the Amp 5.1 and set it to the factory settings.
Caution: All settings you have made and stored on the amplifier's WiFi module will be deleted!
To perform the reset using the touch keys on top of the amplifier, proceeed as follows:
Power up your Amp 5.1 using the Power " " key.
1
To enter the menu, press the input select key "
2
Use the "+" or "-" key to navigate to the menu Network Setup [NWS] and confirm with the Play/Pause button " ".
3
Select the function Network Reset [NWR] and confirm with the Play/Pause button " ". The display shows [YES], the OSD indicates
4
"Reset All".
[NWC]
" until the display shows [SPS] and the Main Menu is entered.
English
3 1 09