Canton Smart Amp 5.1 Manual page 33

English
The CEC functions supported by the Smart Amp 5.1 are:
- One touch Play: By pressing the "Play" button of e.g. a Blu-Ray player the Amp 5.1 switches on automatically and changes to the
corresponding HDMI® input.
- System Standby: With the TV switched on and then turning it into standby mode by pressing the "Power" key the Amp 5.1 also goes
automatically into standby mode.
Note: Depending on the programming of the TV device, the Amp 5.1 can also be automatically activated with the TV.
- Volume/Mute: The volume of the Amp 5.1 can be operated using the Mute and Volume buttons of the TV remote control.
To activate/deactivate this function please proceed with the following steps:
To enter the Menu, press the "M" button.
1
Use the " " or " " button to select the menu item System Setup [SYS] and confirm with the "OK" button.
2
Use the " " or " " button to select the menu item HDMI CEC [CEC] and confirm with the "OK" button.
3
Use the " " or " " button to select "OFF" [OFF] to disable the CEC function resp. "ON" [ON] to enable the function.
4
Press the "M" button to exit this menu item.
5
•Many device manufacturers have developed their own protocols for controlling their devices based on the CEC standard. This can
Notes:
mean that the functions described above only function partially or does not function at all.
•In order to avoid conflicts when controlling the Smart Amp 5.1, the "Volume +/–", "Mute" and "Power" buttons on the TV remo-
te control should not be learned through the IR learn function of the amplifier when using the CEC function. Delete the codes if
necessary.
Standby Mode [STB]
This function controls, how the Amp 5.1 powers up resp. down – manually or automatically, partly dependent on an incoming audio signal.
The Amp 5.1 supports the following functions:
• ECO [ECO]: If ECO is selected, the Amp 5.1 enters standby mode after 20 minutes without any detected audio signal at the selected
input and needs to be powered up manually using the remote control.
• Network [NSB]: If Network [NSB] is selected, the Amp 5.1 must be turned on manually and will automatically enter standby after 20
minutes without detected audio at the selected input. However, there is a difference to the ECO mode, as described below. Network
[NSB] is the default setting of the Amp 5.1.
• Auto [AUT]: If Auto is selected, the Amp 5.1 turns on automatically if an audio signal is detected at any input. If no signal is detected
any longer, the
102