Canton Smart Amp 5.1 Manual page 51

English
To establish a (wireless) connection between the Amp 5.1 and (Smart) speakers, please do the following:
Caution: Before starting the pairing process, the speaker to be paired (slave speaker) must have been disconnected from the mains for at
1
least 30 seconds. Please unplug the power chord from the mains or switch the speaker off using the power switch.
To enter the menu, press the "M" button.
2
Use the " " or " " button to select the menu item Output Setup [OPS] and confirm with the "OK" button.
3
Use the " " or " " button to select the menu item Speaker Mapping [SPM] and confirm with the "OK" button.
4
Use the " " or " " button to select the speaker that you want to adjust and/or pair and confirm with the "OK" button.
5
If you did not set a speaker or pair of speakers to Smart in the Speaker Config menu [SPC], this option will not be available and Wireless
can not be selected.
Use the "+" resp. the "–" key to chose between Wireless (if available) and Analog (Analog 1 - Analog 5 / Analog6).
6
If you want to use the outputs Analog 1 - Analog 5 and/or Analog 6 / Sub Out you can exit the menu after selecting the output by pres-
sing the "M" button.Please repeat this step for all "not Smart" speakers.
If you want to connect your Smart speaker, "Wireless" will be the only selectable option. The abbreviations behind Wireless have the
7
following meanings:
• Wireless (DIS) = Smart speaker not connected (Disconnected)
• Wireless (PIR) = Smart speaker pairing started (Pairing)
• Wireless (CON) = Smart speaker connected
Pressing the "OK" button guides you to the pairing process. The indication on the screen changes from Wireless to Wireless(PIR).
8
The info bar on top of the menu changes from "Wireless pairing press OK" to "Pairing in process". The display shows the selected spea
ker.
Connect the speaker you want to pair to the mains and – if applicable – switch this speaker on at the power switch within 20 seconds.
9
It does not matter if the speaker remains in stand by mode or if it starts up after you connected it to the mains.
After a few seconds a successful wireless pairing will be indicated with Wireless(CON) behind the selected speaker on the screen.
10
The newly paired Smart speakers shows [CON] in its display. From now on the displays of the Smart Amp 5.1 and the paired Smart spea-
ker are in sync and show the selected speaker. The infor bar on top of the menu shows "Pairing successful".
The Amp 5.1 automatically jumps to the next speaker in the list after a successful pairing. Please repeat the steps 7 to 10 to connect addi-
11
tional speakers.
Exit the menu item by pressing the "M" button.
12
120