Canton Smart Amp 5.1 Manual page 50

To set if a speaker / -pair is available and the speaker type please do as follows:
To enter the menu, press the "M" button.
1
Use the " " or " " button to select the menu item Output Setup [OPS] and confirm with the "OK" button.
2
Select the first menu item Speaker Config [SPC] and confirm with the "OK" button.
3
Use the " " or " " button to select the speaker / -pair that you want to adjust the settings of and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to select the desired speaker type and return to the speaker list by pressing the "M" button.
5
Please repeat the steps 4 and 5 until all speakers / pair of speakers are set.
6
Exit the menu item by pressing the "M" button.
7
Speaker Mapping [SPM]
The Speaker Mapping [SPM] allows you to set up the connection between the Smart Amp 5.1 and the speakers. Only speakers that have
been activated in the Speaker Config menu [SPC] can be connected. The connection can be wireless for Smart speakers or wired for passive
speakers using the speaker outputs Analog1 to Analog5 plus Analog6 for a passive subwoofer. Maximum 6 speakers can be connected ana-
logue using speaker cables (5 passive speakers and one passive subwoofer) and 8 Smart speaker can be connected wirelessly. The names of
the speaker terminals on the rear panel of the Amp 5.1 correspond with the factory default routing of the channels Front Left [FL], Front Right
[FR], Surround Left [SL], Surround Right [SR], Center [CE] and Subwoofer [SUB].
The following three connection types are available:
• Canton Smart speakers with the connection type Wireless: In this case audio signals and control signals (On/Standby state, volume, etc.)
are transmitted wirelessly. To establish a wireless connection between the Smart Amp 5.1 and Smart speakers they need to be paired.
• Passive speakers with the connection type Analog 1 to Analog 5: With this connection type passive speakers receive the audio signal using
a speaker cable.
• Subwoofer with the connection type Wireless, Sub Out or Analog1-6: A Smart subwoofer can be connected wirelessly or wired using a
RCA cable to connect the analogue input of the subwoofer with the Sub Out of the Amp 5.1. You can connect a passive subwoofer or an
active subwoofer with high-level-inputs (speaker terminals) to the speaker outputs 1-6 if you set the subwoofer to Analog in the Speaker
Config Menu [SPC]. It is recommended to use the output 6 to connect a passive subwoofer because this output is for subwoofer connec-
tions only. An active subwoofer can also be connected using a RCA cable to the Sub Out of the Amp 5.1
English
3 1 19