Canton Smart Amp 5.1 Manual page 49

English
For the following speaker channels you can find different speaker types in the Speaker Config [SPC] menu:
• Front Left and Front Right [FRT]: Smart, Large, Small
• Center [CE]: NO, Smart, Large, Small
• Surround Left and Surround Right [SUR]: NO, Smart, Large, Small
• Rear Left and Rear Right [RER]: NO, Smart, Large, Small
• Top Front Left and Top Front Right [TF]: NO, Smart, Downfire, Upfire
• Top Rear Left and Top Rear Right [TR]: NO, Smart, Downfire, Upfire
• Subwoofer [SUB]: NO, Smart, Analog
Individually those speaker types have the following meaning:
• Smart [SMT]: This type refers to speakers of the Canton Smart series. You can connect the audio signal wirelessly or wired (using a signal
cable).The control commands (On/Standby state, volume, etc.) are always send wirelessly to the speakers. When using a Smart speaker the
selection of the size and crossovers happens automatically. A 2.0 configuration with the speakers Front Left [FL] and Front Right [FR] is the
minimum setup, which is why the the type [NO] is not selectable.
• Large [LAR]: Please use this type for large passive speakers that are connected to the speaker terminals of the Amp 5.1. The full audio signal
will be routed without any frequency filtering.
• Small [SMA]: Please use this type for small passive speakers that are connected to the speaker terminals of the Amp 5.1. The audio signals
above the set crossover frequency (e.g. 100Hz) will be routed to the small speakers. All frequencies below will be routed to the subwoofer.
• NO [NO]: Please use this type if you do not use the speaker channel and no speaker is placed on the corresponding position.
• Downfire [CEI]: Please select this type when using speakers that are mounted on the ceiling to reproduce Dolby Atmos
• Upfire [UP]: Please select this type when using upfiring speakers (Dolby Atmos
in case on the surround or rear speakers.
• Analog [ANA] (Subwoofer only) : Because there is no difference made between a small subwoofer and a large subwoofer, you can only
select Smart, NO and Analog for using a passive subwoofer resp. an active subwoofer.
118
® Enabled Speaker) that are placed on the top of the front and
signals.
®