Run Start-Up Guide; Alarm Log; Warning Log; Assist - Grundfos TPE 1000 Series Installation And Operating Instructions Manual

Related information
30. Factory settings

13.37 Run start-up guide

Pump variant
TPE, TPED
NBE, NBGE, NKE,
NKGE & TPE, TPED,
NBE, NKE Series 2000
This menu is only available in the advanced control
panel.
The startup guide automatically starts when you start
the pump for the first time.
You can always run the startup guide later via this
menu.
The startup guide guides you through the general
settings of the pump.
• Language. See section "Language".
• Select date format. See section "Date and time"
(Set date and time).
• Set date. See section "Date and time" (Set date
and time).
• Select time format. See section "Date and time"
(Set date and time).
• Set time. See section "Date and time" (Set date
and time).
• Setting of pump
- Go to Home
- Run with Constant curve/Run with
Constant pressure. See section "Control
mode"
- Go to "Assisted pump setup". See section

"Assisted pump setup".

- Return to factory settings.
*Applies only for pumps with advanced functional
module, FM 300. For further information, see section
Identification of functional module.
Related information
13.5 "Control mode"
13.25 Language
13.26 "Date and time" (Set date and time)
13.41 Assisted pump setup
20. Identification of functional module
58
Run start-up guide
●
●

13.38 Alarm log

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
This menu contains a list of logged alarms from the
product. The log shows the name of the alarm, when
the alarm occurred and when it was reset.

13.39 Warning log

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
This menu contains a list of logged warnings from the
product. The log shows the name of the warning,
when the warning occurred and when it was reset.

13.40 Assist

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
The menu consist of functions which take you through
the steps needed to set the pump.
13.41 Assisted pump setup
Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
The menu guides you through the following:
Setting of pump
• Selection of control mode. See section "Control
mode".
• Configuration of feedback sensors.
• Adjusting the setpoint. See section Setpoint.
• Controller settings. See section "Controller"
("Controller settings").
Alarm log
●
●
Warning log
●
●
Assist
●
●
Assisted pump setup
●
●