Homedisplay - Grundfos TPE 1000 Series Installation And Operating Instructions Manual

Pos. Symbol Description
Makes the pump ready for
operation and starts, and stops
the pump.
Start:
If you press the button when the
pump is stopped, the pump only
starts if no other functions with
higher priority have been
5 enabled. See section Priority of
settings.
Stop:
If you press the button when the
pump is running, the pump is
always stopped. When you stop
the pump via this button, the
icon appears in the bottom of the
display.
6 Goes to the Home menu.
Related information
13.28 "Buttons on product" (Enable/disable settings)
16. Priority of settings
17. Grundfos Eye
22
11.1 Home display
1
Home
Setpoint
5.00 bar
Operating mode
Normal
9 8
Example of Home display
Pos. Symbol Description
Home
This menu shows up to four
user-defined parameters. You
can select parameters shown as
1
shortcut icon
pressing
"Settings" display for the
selected parameter.
Status
This menu shows the status of
2 -
the pump and system as well as
warnings and alarms.
Settings
This menu gives access to all
setting parameters. You can
3 - make detailed settings of the
pump in this menu.
See section Description of
functions.
Assist
This menu enables assisted
pump setup, provides a short
4 - description of the control modes
and offers fault advice.
See section Selection of control
mode.
Indicates that the pump has
5
been stopped via the
2 3 4
Status Settings Assist
Control mode
Const. pressure
Actual controlled value
4.90 bar
1
7 6 5
Setpoint
5.00 bar
, and when
Operaring mode
you go directly to the
Normal
1
Setpoint
1
5.00 bar
Setpoint
button.
Operaring mode
Operaring mode
Normal
2
Stat
Con
Co
Actua
4
9 8 7 6
2
Stat
Con
2
Co
Status
Contr
5.00 bar Con
Actua
Actual
Normal
4.
4
9 8 7 6