Run Start-Up Guide; Alarm Log; Warning Log; Assist - Grundfos TPE Series Installation And Operating Instructions Manual

13.37 Run start-up guide

Pump variant
TPE, TPED
NBE, NBGE, NKE,
NKGE & TPE, TPED,
NBE, NKE Series 2000
This menu is only available in the advanced control
panel.
The startup guide automatically starts when you start
the pump for the first time.
You can always run the startup guide later via this
menu.
The startup guide guides you through the general
settings of the pump.
• Language. See section
• Select date format.
See section 13.26 "Date and time" (Set date and
time).
• Set date.
See section 13.26 "Date and time" (Set date and
time).
• Select time format.
See section 13.26 "Date and time" (Set date and
time).
• Set time.
See section 13.26 "Date and time" (Set date and
time).
• Setting of pump
– Go to Home
– Run with Constant curve/Run with Constant
pressure.
See section 13.5 "Control mode"
– Go to "Assisted pump setup".
See section 13.41 Assisted pump
– Return to factory settings.
* Applies only for pumps with advanced functional
module, FM 300. For further information, see
section 20. Identification of functional

13.38 Alarm log

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
This menu contains a list of logged alarms from the
product. The log shows the name of the alarm, when
the alarm occurred and when it was reset.
48
Run start-up guide
●
●
13.25 Language.
setup.
module.
Alarm log
●
●

13.39 Warning log

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
This menu contains a list of logged warnings from
the product. The log shows the name of the warning,
when the warning occurred and when it was reset.

13.40 Assist

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
The menu consist of functions which take you
through the steps needed to set the pump.

13.41 Assisted pump setup

Pump variant
TPE, TPED, NBE,
NBGE, NKE, NKGE
TPE, TPED, NBE, NKE
Series 2000
The menu guides you through the following:
Setting of pump
• Selection of control mode. See page 27.
• Configuration of feedback sensors.
• Adjusting the setpoint. See page 26.
• Controller settings. See page 38.
• Summary of settings.
Warning log
●
●
Assist
●
●
Assisted pump setup
●
●