Transmitting Data (Only Cond 3400I); Data Transmission Interval (Int 2, Cond 3400I) - wtw Cond 3300i Operating Manual

Handheld meter

Hide thumbs Also See for Cond 3300i:

Table of Contents

Operation

4.5

Transmitting data (only Cond 3400i)

You have the following possibilities of transmitting data:

One of the following options:

– With the AutoStore function (page 31), measured values are

periodically saved internally (save interval Int 1) and output on the

interface.

– With the Data transmission interval function (Int 2), measured values

are periodically output on the interface (see below).

With the Output data storage function (page 33), calibration data or saved

measured values are output on the interface.

Via the analog recorder output (page 40), measured values are output as

voltage values.

With the KOM pilot communication kit (accessory), data can be transmit-

ted bidirectionally (page 41).

Note

If you connect a recorder (analog output), the output on the digital interface

is switched off.

The interval to the data transmission (Int 2) determines the chronological in-

terval between automatic data transmissions. After the selected interval ex-

pires, the current data record is transmitted to the interface.

Note

When the AutoStore function is active, the data transmission is performed

according to the setting of the save interval (Int 1). Set the save interval (Int 1)

to OFF to activate the Data transmission interval (Int 2).

Cond 3300i/3400i

ba75684e02

03/2008

Table of Contents

Cond 3400i