Configuration - wtw Cond 3300i Operating Manual

Operation
Baud rate
(Cond 3400i)
42
4.6

Configuration

You can adapt the measuring instrument to your individual requirements. To
do this, the following parameters can be changed (the status on delivery is
marked in bold):
Baud rate
Calibration interval (Int 3)
AutoRange ARng
Reference temperature
Display of the measured val-
ue as conductivity or specific
resistance
Date/time
Note
You can leave the configuration menu at any time with <M> . The parameters
that have already been changed are stored.
1 Switch off the measuring instrument.
2 Press the <M> key and hold it down.
3 Press the <ON/OFF> key.
The display test appears briefly on the display. The measuring instru-
ment then switches automatically to the setting of the baud rate.
UpH O
TDS
S
n t
1 2
8
4 0
Time Baud
Day.Month No.
Year
Ident
Tref25 Tref20 AutoCal DIN
LoBat nLF AutoCal TEC
Lin Cal
4 Select the required Baud rate with <▲> <▼>.
5 Confirm with <RUN/ENTER>. Int 3 appears on the display.
1200, 2400, 4800, 9600
1 ... 180 ... 999 d
On or off
– 25 °C (TREF25)
– 20 °C (TREF20)
S/cm or MΩ
Any
Sal
mV/pH
% mg/l
m S/
cm
M cm
mbar
1/ cm Sal
0
° C
/
% K
TP
°
F
Auto Store
ARng
AR RCL
Cond 3300i/3400i
ba75684e02 03/2008