Outputting The Data Storage - wtw Cond 3300i Operating Manual

Cond 3300i/3400i
Outputting stored
data on the display
ba75684e02 03/2008

4.4.3 Outputting the data storage

You can output the contents of the data storage:
Stored data on the display
Calibration data on the display
Stored data on the serial interface (only Cond 3400i)
Calibration protocol to the interface (only Cond 3400i)
1 Press the <RCL> key repeatedly until StO dISP appears on the dis-
play.
TDS UpH O
S
S T O
1
d I s
Time Baud
Day.Month No.
Year Ident
Tref25 Tref20 AutoCal DIN
LoBat
nLF Lin Cal AutoCal TEC
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx. 2 s,
then the respective temperature appears.
UpH O
TDS
S
1 5 5 3
0 2 0 5
Time Baud
Day.Month No.
Year Ident
Tref20
Tref25 AutoCal DIN
LoBat nLF Lin Cal AutoCal TEC
You can perform the following activities:
Display further elements of the data record
(ID number, date, time, storage location)
Advance one data record (storage location)
Go back one data record (storage location)
Sal
mV/pH
% mg/l
m S/
cm
mbar M cm
1/ Sal
cm
p
°
C
/
% K
TP
° F
Auto Store
ARng
AR RCL
Sal
mV/pH
% mg/l
S/
m
cm
mbar M cm
1/ cm Sal
°
C
/
% K
TP
°
F
Auto
Store
ARng
AR RCL
Operation
Press
<RUN/ENTER>
Press <▲>
Press <▼>
33