Table of Contents
Advertisement
SEV-00184-01
Email Address
The system can send data to the user's email
account if this option is configured (Figure 145).
In the system screen, the user is only setting up
the outgoing, or 'from', email information. The
'to' information is entered for each cartridge
individually when setting up a run. RCC files will
be compressed into a ZIP file and emailed to the
account listed for each cartridge.
NOTE:
Contact trained IT personnel for
assistance when configuring email settings on
the Digital Analyzer.
There are several settings required to configure email on the Digital Analyzer. Use the arrows on the
right to advance through all settings:
•
SMTP server: Simple Mail Transport Protocol (SMTP) is the network protocol used to send
email across the Internet. This setting must be configured correctly, or outgoing email will not
be sent. Enter the name of the SMTP server for outgoing email.
•
SMTP port: Enter the name of the port used by the SMTP server.
•
from address: Enter a valid email address. This address will be seen in the "From" line of any
outgoing emails sent from the system.
•
from security: Security is disabled by default. To enable security on the Prep Station, press
from security and then enter the from password.
•
from password: If security is enabled, enter the appropriate password for the email address.
•
test address: After entering the above information, enter a valid email address to test the
email settings.
NOTE:
NanoString recommends testing email settings prior to setting up a run. Press the
test button and confirm that a message was delivered to the inbox of the test email
address.
Email accounts can be deleted from the Digital Analyzer as well. To delete an email address, press
the email accounts button from the 'Email configuration' screen (Figure 145).
Figure 145: The 'Email configuration' screen.
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
nCounter Pro Analysis System User Manual
93
Advertisement
Table of Contents
