Table of Contents
Advertisement
nCounter Pro Analysis System User Manual
If all samples for the selected cartridge are
defined appropriately, press done. To define
more samples for the cartridge, press the
samples
button
information as described in Steps 9–11 until all
desired tubes in the cartridge have been
defined. When all samples for the cartridge are
defined, press done.
The 'Select CDF Destination' screen will appear
(Figure 80).
13.
Select an existing folder or create a new folder
in which to save the CDF. Press next.
The 'Enter new cdf name' screen will appear
(Figure 81).
14.
Enter the CDF name using the screen's keyboard
and press enter.
If the CDF name already exists, an error will
display, and the instrument will ask if it should
overwrite the existing file. Select no to change
the name of the CDF.
A confirmation message will appear after
successfully naming the CDF (Figure 82).
15.
From the Main Menu, it is now possible to select
start counting, using the CDF that was just
created and saved (see the next section,
Initiating a
Run).
FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.
58
and
continue
to
enter
Figure 80: The 'Select CDF Destination' screen.
Figure 81: The 'Enter new CDF name' screen.
Figure 82: The new CDF name confirmation
screen.
SEV-00184-01
Advertisement
Table of Contents
