Safety Instructions; General; Maintenance - Pentair BAA A390-D.03 Select Operating Instructions Manual

Svp aseptic change-over valve

Hide thumbs

Table Of Contents

Table of Contents

This symbol indicates a direct and immediate danger to the life and health

of persons!

Failure to observe these warnings may result in serious damage to health,

Danger

up to and including life-threatening injuries which may or may not be fatal.

This symbol indicates a potentially hazardous situation!

Failure to observe these warnings may result in less serious injuries, or

damage to material property.

Caution

This sign draws your attention to important information about the proper use

of the SVP aseptic change-over valve. It is essential for this information to be

observed.

Failure to observe these instructions may cause malfunctions in the valve or

in its vicinity.

2.1.

General

⇒ SVP aseptic change-over valves from Pentair Südmo GmbH are manufactured in accordance with state-of-the-art standards and the recog-

nized safety rules. However, these SVP aseptic change-over valve may constitute a hazard if used by operating personnel improperly or for a

purpose other than the intended one. This may result in a risk to life and limb of the user or of third parties, or cause damage to the SVP asep-

tic change-over valve and other material propertyn.

⇒ Each person concerned with installation, commissioning, operation and maintenance of this SVP aseptic change-over valve must have read

and understood the complete operating instructions, and in particular all safety instructions.

⇒ In addition to these operating instructions, the following are of course also valid:

 pertinent accident prevention regulations

 generally recognized safety rules

 national regulations of the country of use

 in-house work and safety regulations.

2.2.

Maintenance

⇒

Any maintenance and service work on the SVP aseptic change-over valves must be carried out by specially trained, qualified personnel only.

 Training or instruction in accordance with the current safety standards.

 For systems with explosion protection: training or instruction or authorization to carry out work on systems

Copy of original operating instructions

Operating instructions

SVP aseptic change-over valve, pneum. operated

diaphragm – O-ring

DN 010 – 020, OD 0.50" – 0.75"; ISO 008 – 015