Related Manuals for Pentair JUNG PUMPEN BASICLOGO BD
Summary of Contents for Pentair JUNG PUMPEN BASICLOGO BD
- Page 1 BASICLOGO BD BD 00 E - BD 00 EN Instruction Manual JUNG-PUMPEN.DE B 55738.10-2023.02...
-
Page 2: Safety Instructions
ENGLISH You have purchased a product made by JUNG PUMPEN and SAFETY INSTRUCTIONS with it, therefore, also excellent quality and service. Se- cure this service by carrying out the installation works in This instruction manual contains essential information that accordance with the instructions, so that our product can must be observed during installation, operation and servicing. -
Page 3: Technical Data
ENGLISH Unauthorised operating methods DESCRIPTION The operational safety of the supplied equipment is only guar- anteed if the equipment is used for its intended purpose. The Electronic control unit for level control of two d.o.l. starting limiting values given in the "Technical Data" section may not be submersible pumps. - Page 4 ENGLISH FAULTS ASSEMBLY WARNING! When using the pumps, the relevant national laws as well as national and local regulations must be complied with. Before carrying out any work: Disconnect the pump and the control unit from the mains and take action to ensure that no WARNING! one else can reconnect them to the power supply.
-
Page 5: Maintenance
ENGLISH Note on BD 00. The motor protection switch only protects er “BRX1” near the buzzer. To prevent the jumper from getting against a short-circuit in the pump. The current at the motor lost, re-attach it to a pin on the two-pole pin connector. protection switch must therefore be adjusted to the maximum External alarm buzzer (accessory) setting. - Page 6 BD 00 If pumps without a winding thermostat are connected, insulated wire bridges must be laid from: A2 (Q1/Q2) to 23 (Q3/Q4)
- Page 7 BD 00E...
- Page 8 UKCA-Declaration of Conformity Legislation - Designated Standards • Electromagnetic Compatibility Regulations 2016 EN 55014-1: 2017/A11:2020, EN 55014-2: 1997/A2:2008 (EMC) • The Restriction of the Use of Certain Hazardous Substance in Electrical and Electronic Equipment Regulations 2012 (RoHS) • Electrical Equipment (Safety) Regulations 2016 EN 60335-1: 2012/A14:2019, EN 60204-1:2018 Name and address of the manufacturer: JUNG PUMPEN GmbH - Industriestr.
- Page 10 Tel. +39 050 716 111 Tel. +48 32 295 1200 kd@jung-pumpen.de info@jung-pumpen.it infopl.jungpumpen@pentair.com All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners. © 2023 Pentair Jung Pumpen...
Need help?
Do you have a question about the JUNG PUMPEN BASICLOGO BD and is the answer not in the manual?
Questions and answers