Control Modes; One Spectral (Static Colors); One Spectral (Built-In Programs); Multiple Spectrals (Master/Slave Control) - SHOWTEC Spectral M400 IP67 Manual

Spectral M400 IP67

Control Modes

There are 4 modes:

One Spectral (Static Colors)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 15 for more information about the static colors.

One Spectral (Built-in programs)

04) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
05) Plug the end of the electric mains power cord into a proper electric power supply socket.
06) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 16 for more information about the built-in programs.

Multiple Spectrals (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a special 3-pin XLR cable to connect the Spectral.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using the included DMX extension cables. Link the second, third, and fourth units.
04) You can use the same functions on the master device as described on pages 15-16 (Static colors
and Built-in programs). This means that you can set your desired operation mode on the master
device and all slave devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Ordercode: 43534
• Static Colors (Manual)
• Built-in programs (Auto)
• Master/Slave
• DMX-512 (9CH, 13CH, 3CH, 3CH, 4CH, 5CH)
01) Earth
02) Signal -
03) Signal +
10
Fig. 03