Spectral M400 IP67
Backside
Fig. 02
04) 4-digit LED display + menu buttons
05) Special 3-pin DMX signal cable IN
06) Power cable 100-240V IN
07) Power cable 100-240V OUT
08) Special 3-pin DMX signal cable OUT
09) Safety eye
Installation
Remove all packing materials from the Spectral M400 IP67. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 43534
9