Built-In Programs; Master/Slave Mode; Dmx-512 Mode; Dmx Channel Modes - SHOWTEC Spectral M400 IP67 Manual

Spectral M400 IP67

2. Built-in programs

With this menu, you can set the built-in programs.
01) Press the UP/DOWN buttons until the display shows
menu.
02) Press the UP/DOWN buttons to choose one of the 10 uneditable built-in programs (AT.01-AT.10) and
10 editable presets (PR.01-PR.10) which can be edited in Edit mode (see page 17).
03) Press the ENTER button to activate.
04) The device will now run the desired built-in program.

3. Master/Slave Mode

With this menu, you can set the device as a slave.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the 2 following options:
04) When the display shows
05) When the display shows
same as the master device.

4. DMX-512 Mode

With this menu, you can set the DMX address.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to choose the desired DMX address. There are 512 available DMX
addresses to choose from.

5. DMX channel modes

With this menu, you can set the desired DMX channel mode (personality).
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following DMX channel modes:
TOUR:
9 channels
TR16:
13 channels
ARC.1:
3 channels
Ordercode: 43534
DMX/Master Mode
Slave Mode
, the display is operating in DMX/Master Mode.
, the device is operating in Slave Mode. It means that it will react the
AR1.d:
4 channels
AR1.S:
5 channels
HSV:
3 channels
16
and press the ENTER button to open the
.
.
.