Configuring Netware File Server To Connect To Logical Printers - NETGEAR PS104 Installation And Reference Manual

Select Logical Printer Configuration, and then set the items listed in
3.
the appropriate entry fields.
Table 5-3. Logical Printer Configuration Entries
Entry Field
Physical Port
String Before Job
String After Job
Convert LF to CR+LF If On is indicated in the entry field, LF (line feed) characters are changed to CR+LF

Configuring NetWare File Server to Connect to Logical Printers

The NetWare PCONSOLE must be used to create connections to logical ports and assign print
queues to the ports. When creating logical printers, be sure to select printer numbers greater than 7
from the Configured Printer listing. When operating in a NetWare environment, all printer
numbers greater than 7 are logical printers. Remember that selecting printer 8 corresponds to
logical printer L1, selecting printer 9 corresponds to logical printer L2, and so on up to printer 15,
which corresponds to logical printer L8.
Refer to Table 5-2 on
For more information about using NDPS, refer to
Novell NetWare Printing
Installation and Reference for the Model PS104/PS105/PS110 Print Server
Definition
Select the physical port for this logical printer (P1 to P2 for parallel ports). Logical
printers are numbered from L1 to L3 for the Model PS 104 and Model PS105 print
server and numbered L1 to L8 for the Model PS110 Print Server.
The printer control string (in hexadecimal notation) to be sent to the printer before
each print job. The maximum number of ASCII characters in the control string is 15.
The examples are:
• ASCII = [Esc]&10O
Hexadecimal = 1B266C304F
• ASCII = [Esc]&110
Hexadecimal = 1B266C314F
The printer control string (in hexadecimal notation) to be sent to the printer after
each print job. The maximum number of ASCII characters in the control string is 15.
(carriage return + line feed). If Off, no conversion is done.
page 5-8 for printer name mapping.
Appendix D, "Using NetWare 5
Table 5-3 in each of
NDPS."
5-23