NETGEAR PS104 Installation And Reference Manual page 119

Add the print server to the /etc/hosts file by adding to the file:
3.
IP_Address NAME # Comment
Use these definitions for entering the information:
• IP_Address is the IP address of your print server.
• NAME is the name of your print server.
A sample entry is:
192.10.2.54 PS_Rm203 #Default name PS123456
In the example, a print server with an IP address of 192.10.2.54 is called PS_Rm203 and has a
default name of PS123456.
Add to the Ethernet Address table /etc/ethers:
4.
00:c0:02:xx:yy:zz NAME
Use these definitions for entering the information:
• 00:c0:02:xx:yy:zz is the location of your print server.
• NAME is the name of your print server.
Reset the print server by turning the power off and then on again.
5.
When the print server reboots, it acquires an IP address using RARP.
To assure that an IP address has been assigned, check the IP address to MAC address
6.
association using the ping command:
ping NAME
NAME is the name of the print server. You should receive a response. If you get a timeout
message, the RARP procedure has failed. You can either follow the steps again for using
RARP or use one of the other methods for assigning an IP address.
Proceed to "Configuring Your Print Server Using
7.
print server, if it has not yet been configured.
UNIX Printing Using TCP/IP
Installation and Reference for the Model PS104/PS105/PS110 Print Server
FTP" on page 6-7 to configure the
6-5