Appendix Cconfig File; Config File Tcp/Ip Settings; Table C-1. Configuration Settings - NETGEAR PS104 Installation And Reference Manual

This appendix provides information for editing a CONFIG file. CONFIG files are stored in the
flash EEPROM of the NETGEAR Model PS104/PS105/PS110 print server and used for
configuring the device using the FTP method. For more information about using the CONFIG file
and to see an example of FTP commands, refer to
page 6-7. Only the parameters related to TCP/IP operation of the print server are listed. For
modification of the various NetWare IPX/SPX and NetBEUI settings, NETGEAR recommends
that you use the included FirstGear Print Server Administration Program or the PSCONFIG
program.

CONFIG File TCP/IP Settings

When modifying the CONFIG file, use the configuration settings outlined in
Table C-1. Configuration Settings
Parameter and Command
Device Name
(0001 BOX_NAME)
TCP/IP Protocol
(0012 TCPIP_P)
IP Address
(4000 IP_ADDR)
Device IP Address
(4001 GATEWAY)
CONFIG File
"Configuring Your Print Server Using
Definition
The default name of the print server is PSxxxxxx (PS followed
by 6 numbers). You can change this, but the new name must
not exceed 19 characters and must not include any spaces.
Enables or disables reception or transmission of TCP/IP
packets.
This is the IP address for your print server. For more
information about IP addressing, refer to
"Understanding IP Addresses."
If your network segment has a router, enter the router address
here. If there is no router, leave the address as 0.0.0.0.
Appendix C
CONFIG File
FTP" on
Table C-1.
Appendix B,
C-1