Print Server Configuration - NETGEAR PS111W Installation Manual

If you find any problems:
• Check all connections
• If required, verify the integrity of the print server by resetting it. Turn power to the print
server off and then back on.
• Refer to "Troubleshooting Information" at the end of this document for further
information.

Print Server Configuration

An Administration program and Setup Wizard for Windows is provided to simplify Print
Server configuration. The Administration program and Setup Wizard should only be installed
on one PC, typically the PC used by the LAN administrator.
Installing the Administration Tools and Setup Wizard
1. Insert the NETGEAR Print Server Resource CD into the CD ROM drive. If the auto
setup program is not started, go to 'Start –Run ...'and type 'd: \setup ', where d is the
CD ROM drive letter.
2. A welcome screen runs. Click on Next.
3. A message screen shows some important information. Read the message and click on Next.
4. The "Select Components" screen shows the components you can install from the CD.
There are four (4), as listed below. Click on Next to install all components.
• NETGEAR Print Server Setup Wizard
Use this for quick and easy configuration of the Print Server.
• NETGEAR Add Printer Wizard
This component should be installed on all PCs that need to print to the print server.
See PC Setup for further details.
• Administrative tools
Use this program to manage the NETGEAR Print Server and perform advanced
configuration.
• User Manual
Copy the detailed user's manual and reference guide from the CD onto your PC.
12
All manuals and user guides at all-guides.com