Warranty/Support information card Connect the Print Server The PS121 USB Mini Print Server connects directly to the USB port on your printer. After connecting it to your printer, you then connect the print server to a network device (like a hub, router, or switch).
Note: If either light does not operate as indicated, go to the Troubleshooting section on page 8. The PS121 comes with several software components that allow you to set up the print server and use administrative tools. You should install all the software onto one Windows computer to...
Programs and click NETGEAR Print Server>NETGEAR Print Server Administration. Configure a Computer to Access the Print Server Before using the PS121 on your network, each computer that needs to access the print server must have: • A connection to the network.
To configure computers running Windows 98 and Me: 1. Click Start, point to Programs> NETGEAR Print Server and click NETGEAR Add Printer Wizard. 2. Follow the screen prompts, and click OK in the Setup message window.
Page 6
EN 55 022 Statement This is to certify that the Model PS121 USB Mini Print Server is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022 Class A (CISPR 22).