Table of Contents
Advertisement
2.3 Motherboard Installation
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Tools Needed
Phillips
Screwdriver
(1)
Location of Mounting Holes
Note: 1) To avoid damaging the motherboard and its components, please do not use
a force greater than 8 lbf-in on each mounting screw during motherboard installation.
2) Some components are very close to the mounting holes. Please take precaution-
ary measures to avoid damaging these components when installing the motherboard
to the chassis.
Phillips Screws
(7)
JKVM1
USB0/1
USB2 (3.0)
MH1
MH2
SW1
MH3
JMD2
JMD1
JTPM1
JMD2: M.2-H
JMD1: M.2-H
PCIe 3.0 X4 / I-SATA 3.0
PCIe 3.0 X4 / I-SATA 3.0
MH8
LEDM1
JPME2
SRW1
SRW3
JWD1
J3
J2
JBM1
SRW4
SRW2
JPCIE1
BIOS LICENSE
BAR CODE
SRW5
BT1
MAC CODE
JBT1
X12STD-F
REV: 1.02
S-SGPIO1
DESIGNED IN USA
MH6
CPU
MH7
MH4
MH9
JPWR1
25
Chapter 2: Installation
Standoffs (7)
Only if Needed
Advertisement
Table of Contents
