Supermicro X12STD-F User Manual page 76

Super X12STD-F User's Manual
PEG Bifurcation x8x4x4
Use this feature to select which PEG bifurcation to be x8x4x4. If this feature is disabled, the
bifurcation will be x8x8. The options are Disable and Enable.
JMD1:M.2-H OPROM
Use this feature to select a desired firmware function to be loaded for JMD1. The options are
Disabled and Legacy (if the Boot Mode Select feature under the Boot tab is set to Legacy),
Disabled and EFI (if the Boot Mode Select feature under the Boot tab is set to UEFI), and
Disabled, Legacy, and EFI (if the Boot Mode Select feature under the Boot tab is set to Dual).
JMD2:M.2-H OPROM
Use this feature to select a desired firmware function to be loaded for JMD2. The options are
Disabled and Legacy (if the Boot Mode Select feature under the Boot tab is set to Legacy),
Disabled and EFI (if the Boot Mode Select feature under the Boot tab is set to UEFI), and
Disabled, Legacy, and EFI (if the Boot Mode Select feature under the Boot tab is set to Dual).
Network Configuration

Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unified Extensible
Firmware Interface (UEFI) for network stack support. The options are Disabled and Enabled.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
IPv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media detect count
Use this option to specify the number of times media is checked. Press "+" or "-" on your
keyboard to change the value. The default setting is 1.
76