Supermicro X12STD-F User Manual page 73

SATA Interrupt Selection
Use this feature to select the SATA interrupt. The options are MSI-x, MSI, and Legacy.
Aggressive LPM Support
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller puts the link in a low power mode during extended periods of I/O
inactivity and then returns the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
SATA Port 0-3
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
SATA Port 0-3 Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disabled and Enabled.
SATA Port 0-3 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are Disabled
and Enabled.
SATA Port 0-3 SATA Device Type
Use this feature to specify if the SATA port specified should be connected to a Solid State
Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH-FW Configuration
The following firmware information will display:
•
General ME Configuration
•
Operation Firmware Version
•
Backup Firmware Version
•
Recovery Firmware Version
•
ME Firmware Status #1
•
ME Firmware Status #2
•
Current State
•
Error Code
73
Chapter 4: BIOS