Table of Contents
Advertisement
Super X12STD-F User's Manual
*If the feature above is set to Enabled, the following features are available for
configuration:
EMS Console Redirection Settings
Out-of-Band Mgmt Port
The feature selects a serial port in a client server to be used by the Microsoft Windows
Emergency Management Services (EMS) to communicate with a remote host server. The
options are COM1 and SOL.
Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits Per Second EMS
This item sets the transmission speed for a serial port used in Console Redirection. Make
sure that the same speed is used in the host computer and the client computer. A lower
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control EMS
Use this item to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits EMS, Parity EMS, Stop Bits EMS
SATA And RSTe Configuration
SATA Controller(s)
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disabled.
SATA Mode Selection
Use this feature to select the SATA mode. The options are AHCI and Intel RSTe Premium
With Intel Optane System Acceleration.
*If the feature above is set to Intel RSTe Premium With Intel Optane System Acceleration,
the next four features are available for configuration:
72
Advertisement
Table of Contents
