User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mode
no snmptrap
This command deletes trap receivers for a community.
Format
Mode
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries
using the same IP address, the first entry is retained and processed. All duplicate entries are
ignored.
Format
Mode
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
Mode
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive
traps).
Format
Mode
8-32
Global Config
no snmptrap <name> <ipaddr>
Global Config
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Global Config
snmptrap mode <name> <ipaddr>
Global Config
no snmptrap mode <name> <ipaddr>
Global Config
202-10009-01_060204
Switching Commands