Show Remotecon - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
IP Address
Subnet Mask
Default Gateway
Burned In MAC Address The burned in MAC address used for in-band connectivity.
Locally Administered MAC Address If desired, a locally administered MAC address
MAC Address Type
Network Configuration Protocol Current Indicates which network protocol is being
Java Mode
Management VLAN ID

show remotecon

This command displays telnet settings.
Format
Mode
Switching Commands
The IP address of the interface. The factory default value is
0.0.0.0
The IP subnet mask for this interface. The factory default value is
0.0.0.0
The default gateway for this IP interface. The factory default
value is 0.0.0.0
can be configured for in-band connectivity. To take effect, 'MAC
Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon
between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a
0, i.e. byte 0 should have the following mask 'xxxx xx10'. The
MAC address used by this bridge when it must be referred to in a
unique fashion. It is recommended that this be the numerically
smallest MAC address of all ports that belong to this bridge.
However it is only required to be unique. When concatenated
with dot1dStpPriority a unique BridgeIdentifier is formed which
is used in the Spanning Tree Protocol.
Specifies which MAC address should be used for in-band con-
nectivity. The choices are the burned in or the Locally Adminis-
tered address. The factory default is to use the burned in MAC
address.
used. The options are bootp | dhcp | none.
Specifies if the switch should allow access to the Java applet in
the header frame. Enabled means the applet can be viewed. The
factory default is disabled.
Specifies the management VLAN ID.
show remotecon
Privileged EXEC and User EXEC
202-10009-01_060204
8-23