Motor/Gear Box Assembly (Cts-042, Cts-043) - SawStop CTS-015 Service Manual

Motor/Gear Box Assembly (CTS-042, CTS-043)

Motor/Gear Box Assembly (CTS-042, CTS-043)
Use the instructions in this chapter to install the Motor/Gear Box service kit you received.
WARNING:
To ensure safety during maintenance, disconnect all electrical power to the saw and remove
the saw blade.
NOTE:
For an optimal experience using this service manual, begin maintenance on your saw by
starting with the chapter most directly associated with the CTS service kit you received
containing replacement parts.
IMPORTANT:
If you have the optional stand for the CTS, remove the saw from the stand and perform this
maintenance on a suitable workbench.
Certain maintenance operations may be best performed with your CTS tipped on its edge or
perhaps even flipped upside down to rest on its top. As a result, many photos in this service
manual do not depict the CTS in its normal, upright orientation.
Description
The motor and associated gearbox is of course the heart of the CTS. It's purpose is to spin the saw blade in order to
provide cutting action. It is attached to a series of mechanisms that enable it to be raised, lowered and the bevel
angle changed. Two variants of this motor/gearbox service kit are available:
CTS-042 - 120V, 60Hz Motor (US Version)
l
CTS-043 - 230V, 50Hz Motor (Australia Version)
l
The installation hardware, disassembly and reassembly instructions are identical for both variants.
Below are step-by-step instructions for the disassembly required to remove and then replace the Motor/Gear Box
Assembly.
|
CTS Service Manual 78