SawStop CTS-015 Service Manual page 57

Switch Box Assembly (CTS-038)
6. Remove the four
12mm, Flat Head, Phillips [2]
the
Switch Box Assembly [1]
Phillips head screwdriver.
7. The
Switch Box Assembly [1]
Slip it downward while tipping the
bottom end away from the metal panel
to which it was mounted to remove it
from the saw.
Once removed, set it aside if it is to be
re-installed later. Discard it if a
replacement has been provided in the
service kit you received from SawStop.
Assembly Steps
1. Perform the Disassembly Steps described immediately above in reverse order. If a service kit containing
new parts to replace those removed above was provided, use only the new parts during re-assembly.
2. In reverse order, re-visit each of the chapter(s) listed in the Prerequisites section in this chapter and
perform the Disassembly Steps in reverse order for each.
Inspection Steps
1. Restore power to your CTS and confirm expected operation of each of the controls on the
.
Assembly [1]
|
53 CTS Service Manual
Screws - M4 x 1.8mm,
that secure
using a #2
is now free.
Switch Box