Table of Contents
Advertisement
Elevation Control Shaft (CTS-036)
Elevation Control Shaft (CTS-036)
Use the instructions in this chapter to install the Elevation Control Shaft service kit you received.
WARNING:
To ensure safety during maintenance, disconnect all electrical power to the saw and remove
the saw blade.
NOTE:
For an optimal experience using this service manual, begin maintenance on your saw by
starting with the chapter most directly associated with the CTS service kit you received
containing replacement parts.
IMPORTANT:
If you have the optional stand for the CTS, remove the saw from the stand and perform this
maintenance on a suitable workbench.
Certain maintenance operations may be best performed with your CTS tipped on its edge or
perhaps even flipped upside down to rest on its top. As a result, many photos in this service
manual do not depict the CTS in its normal, upright orientation.
Description
The Elevation Control Shaft is part of the mechanism that facilitates setting the cutting height of the saw blade on
your CTS.
Below are step-by-step instructions for the disassembly required to remove and then replace the Elevation Control
Shaft.
|
CTS Service Manual
38
Advertisement
Table of Contents
