SawStop CTS-015 Service Manual page 22

Fence Rails (CTS-002, CTS-003)
4. Grip the fence rail and slide it to the
left or right to remove it from the saw.
The picture at right depicts removal of
the front rail. The process for the
removal of the rear rail is the same.
Assembly Steps
1. Perform the Disassembly Steps described immediately above in reverse order but this time, you'll use
the new parts contained in the service kit you received from SawStop (If provided).
2. Install the fasteners into the outward facing T-track of
the fence rail extrusion. Place the fasteners at the
spacing illustrated below. (Measurements expressed in
Millimeters.)
Once positioned per the specification below, tighten
using a 4mm Allen wrench.
Front Rail Hardware Placement
|
CTS Service Manual 18