Table of Contents
Advertisement
U-Joint (CTS-037)
3. Next remove the second set screw linking the U-Joint to the
4. Disengage the worm drive and the Elevation Control Shaft from the U-joint. This can typically be done by
hand but a flat head screwdriver may be required to separate these components.
5. Remove the U-Joint. Handle carefully as it will be greasy.
Once removed, set it aside if it is to be re-installed later. Discard it if a replacement has been provided in
the service kit you received from SawStop.
|
63
CTS Service Manual
Elevation Control
Shaft:
Advertisement
Table of Contents
