Rail Lock Handle (Cts-010) - SawStop CTS-015 Service Manual

Rail Lock Handle (CTS-010)

Rail Lock Handle (CTS-010)
Use the instructions in this chapter to install the Rail Lock Handle service kit that you received.
WARNING:
To ensure safety during maintenance, disconnect all electrical power to the saw and remove
the saw blade.
NOTE:
For an optimal experience using this service manual, begin maintenance on your saw by
starting with the chapter most directly associated with the CTS service kit you received
containing replacement parts.
IMPORTANT:
If you have the optional stand for the CTS, remove the saw from the stand and perform this
maintenance on a suitable workbench.
Certain maintenance operations may be best performed with your CTS tipped on its edge or
perhaps even flipped upside down to rest on its top. As a result, many photos in this service
manual do not depict the CTS in its normal, upright orientation.
Description
The Rail Lock Handle is the knob use for locking and unlocking the position of the fence after the fence has been
adjusted to the desired position.
Below are step-by-step instructions for the disassembly required to remove and then replace the Rail Lock Handle.
The disassembly instructions in this chapter also serve as a prerequisite to servicing other aspects of your CTS.
|
CTS Service Manual 26